Results 1 to 6 of 6
  1. #1
    Non-member Russ B's Avatar
    Join Date
    Aug 1995
    Location
    Colchester (Brightlingsea)
    Posts
    140
    Post Thanks / Like

    master cylinder goosed?

    Hi guys.... hope you're all keeping well?
    I had to get my 5 out of the garage to do some work in there & I usually just push her out, but as I wanted to turn her round I thought I'd fire the old girl up. I had to sort a stuck floats valve first as their wasn't any fuel getting into the bowl, but once that was done she fired up straight away as usual. (its been a couple of years since she last ran)
    Anyway I crept along the driveway & the went to stop to turn round & no brakes.... the pedal went straight to the floor...eek...handbrake stopped me of though.lol.
    The pedal goes to the floor regardless of the engine running, so am I right to assume the master cylinder is more than likely goosed? I've never had to change one & the access doesn't look great..... what does with our 5's.lol. Any thoughts guys?

    Cheers

  2. #2
    Committee, Treasurer, Memberships admin Ian S's Avatar
    Join Date
    Sep 2000
    Location
    Essex
    Posts
    5,832
    Post Thanks / Like

    Re: master cylinder goosed?

    Was it just lack of servo assistance, or no brakes at all no matter how hard you pushed the pedal?

    If not short of fluid, then maybe that says the seals in the master cylinder are not sealing. But why would both go at the same time?

  3. #3
    Committee, Moderator Matt Cole's Avatar
    Join Date
    Sep 2008
    Location
    Durham
    Posts
    5,259
    Post Thanks / Like

    Re: master cylinder goosed?

    Ms are cheap enough, bit of a pig to change!

    As Ian has said, the seals in the ms have probably died, most likely perished from being stood so long.

  4. #4
    Non-member Russ B's Avatar
    Join Date
    Aug 1995
    Location
    Colchester (Brightlingsea)
    Posts
    140
    Post Thanks / Like

    Re: master cylinder goosed?

    Thanks for the replies guys

    The pdal went straight to the floor with what felt like no resistance at all Ian..... & no brakes at all either. I seem to recall I did here the servo hissing when the engine was running & the engine note went lumpy as well as I was frantically pumping pedal before pulling the handbrake.lol.

    She's not been on officially on the road since 2010 Matt & only ever been run up with a short blast around (on a private road of coarse ) every couple of months up until a couple of years ago. So I'm surprised that the MS has total failed, but it is old & these things happen I guess. If it was something else then I would have though the pedal would have had some resistance?

  5. #5
    Moderator, Committee Trevhib's Avatar
    Join Date
    Sep 2008
    Location
    Derby
    Posts
    5,829
    Post Thanks / Like

    Re: master cylinder goosed?

    Pedal to the floor with no resistance was the master cylinder when this happened to me in a Fiesta many moons ago. Frightening, and my immediate reaction was the same, to yank the hand-brake!

  6. #6
    Committee, NW Regional Rep Alex's Avatar
    Join Date
    Sep 2000
    Posts
    3,120
    Post Thanks / Like

    Re: master cylinder goosed?

    I would be checking the servo and related pipe work for any leaks or cracks. The underside of the servo in particular can rust.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •