Internal brake pipe fitting, How?

[Kingscott]

Hi Guys

My original rear comp valve has finally died after 20 plus years so I've decided to fit a manual valve in the car.

(My car is non road legal, track only)

My question is, how do I plumb in internal brake lines? Do I run just one line to the rear and split then blank off one output off the master cylinder?

If anyone has internal lines or a manual brake bias valve fitted can you please give me some pointers on where to start? clips, entrance and exit points, materials used.

Any help would be super fab.


Cheers

Adam

[J$£5GTT]

i was going to do this later on using braided lines.

there was a thread with it somewhere regards set up

[Kingscott]

Really I just want to know if I can blank one of the Rear supply ports on the master cylinder and then just do a split at the rear of the car to feed both calipers. Or if I have to t the two into one.....then back to two (if that makes any sense)