my lm1 , wont perform free air calibration, it was working fine , but now the calibrate button has no effect at all.
my lm1 , wont perform free air calibration, it was working fine , but now the calibrate button has no effect at all.
I presume you are holding it down and not just pressing it ?
yea bud.. it has no effect, holding it, pressing it repeatidly.. grrr.. looked on the internet and theres a few people with the same issues, going to try reinstalling the firmware i think .
Innovate = headache Just be glad you didn't spend 350 on a new LM2 when they came out only to find it was total junk. Good luck with it. Maybe check the button itself is working still.
im feeling that aswell , sold my lc1 to get a nice reliable lm1.. now i have issues with this, its probably had less than 2 hours use, unfortunatly over the space of 2 years.
scoff - your old LM1 is still working
just to update.
I sorted this..
the Lm programmer software has a button called reset calibration (this removes all the old calibration data), after that its working again.