-
Member
Bearing/gear pullers
I need to get a few bearing cases of a few hubs ...
Can anyone recommend a decent quality tool that will work more than feckin once ?
Bought a Clarke job, it worked once then has lost the knife edge and won't do the job again BAG-O-****E
-
Motech
Re: Bearing/gear pullers
Do you mean the inner races off the stub axle or pulling the stub out of the bearing in the hub?
Easiest way to get the inner races off is grind it with a slitting disc, otherwise a press with a few odds and sods is best for getting the hubs apart and brearings out, u can pick up an old press pretty cheap
-
Motech
Re: Bearing/gear pullers
lol, rtoc moving on, it just said thank you to me for posting???
-
Member
Re: Bearing/gear pullers
Have a thanks from me as well .
Need to get the inner race off . Will try and slit it ....
Local garage pressed the old lot out and new in for me but I'm left with half a casing stuck to the shaft .
-
Motech
Re: Bearing/gear pullers
np, its the easiest way, takes 2 mins, just dont go too far ull have to do it on a bit of an angle too.
-
Motech
Re: Bearing/gear pullers
they should of done that for you too, suprised they didnt take it off and press it back in? or did you request it seperate?
-
Member
Re: Bearing/gear pullers
I gave them the hub only to just swap the bearings out .Forgot about the bit left stuck to the shaft
-
Motech
Re: Bearing/gear pullers
ah nevermind.
-
Non-member
Re: Bearing/gear pullers
I just carefully grind the inner race off, miles easier than struggling to pull it off.
-
Member
Re: Bearing/gear pullers
Careful ,grinder and Me
-
Re: Bearing/gear pullers
mini grinder works a treat
-
Non-member
Re: Bearing/gear pullers
Grind it thin then hit it with a chisel, works everytime for me
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules